T series synchronous motor is suitable for driving blowers, pumps, steel rolling and other general machinery;
TK series synchronous motor is suitable for specially for reciprocating compressors are used in refrigeration and fertilizer equipment;
TM series synchronous motor is suitable for driving synchronous motors used in mining mills, mainly driving ball mills, rod mills, coal mills, etc.
T, TK, TM series motors are installed in indoors where the altitude does not exceed 1000 meters, the cooling medium temperature does not exceed 40 degrees, the use environment is less dusty, and there are no corrosive gases such as acids and alkalis. It is not allowed to work in environments containing explosive gases .
The rated power of the motor is 50HZ, the rated power factor is 0.9 (leading), the rated voltage is 6KV and 10KV. It can also provide synchronous motors with different voltages and different frequencies according to user requirements.
Motor shaft extension types include single shaft extension, dual shaft extension, and no shaft extension modes.
The direction of rotation of the motor is seen from the end of the slip ring, generally counterclockwise, or clockwise according to requirements.
The shaft extension of the motor cannot bear the applied radial or axial force.
The excitation device of the motor is generally a thyristor excitation device.
The motor allows full voltage to start directly. If the user"s power grid does not allow direct starting, a reduced voltage start can also be used. At this time, the dynamic current of the motor decreases in proportion to the terminal current, and the starting torque decreases in proportion to the square of the terminal voltage.
The ventilation mode of this series of motors is open natural ventilation. It can also be made into fully enclosed duct ventilation or collector ring positive pressure ventilation.
Machine base: welded with steel plate, the lower part of the machine base is the outlet end of the motor.
Stator: The stator core is made of 0.5 mm thick low-loss silicon steel sheet punched with fan-shaped sheets, and the core sections are separated by radial air duct pieces. Class F insulation.
Rotor: The magnetic pole is stamped out of steel plate, and it is installed on the magnetic pole of the rotor together with the magnetic pole coil, and the magnetic pole line is B-level or F-level insulation.
Stator outgoing wire: There are six appearing heads, labeled U1, V1, W1, U2, V2, W2, which are led out on the upper outgoing clamp of the machine base with high-voltage rubber cable.
Seat bearing: Use oil ring bearing or compound bearing. The seat bearing is installed on the bottom plate, and there is an insulating pad between the bearing seat and the bottom plate to prevent the shaft current.