3800kg Halal slaughter equipment cow/cattle/beef slaughter 2.2kW Safety and efficiency 


This machine is commonly used in meat processing enterprises mechanical equipment. This machine has the hydraulic pressure system and the mechanical locking system to carry on the joint control, this machine can realize the cattle to turn over the board slaughter, satisfies the religious slaughter live cattle does not strike unconscious situation slaughter request, has the work stability noise small maintenance convenience and so on characteristics, and so on. It is an indispensable equipment in cattle slaughtering line. 





the point of operation safety:

1) it is strictly prohibited to put other things such as hands into the machine while working to prevent injury to people or damage to the machine; if the machine appears abnormal working sound, it should stop and check immediately to prevent serious damage to the machine and injury to the personnel;

2) the machine must be cleaned and maintained at the time of stopping, and make sure that the power supply has been cut off and the warning card is hung;

3) when the work is finished, turn off the power supply;

4) the operator shall have the knowledge of mechanical and electrical operation and be in good health;

5) the operator should be familiar with the structure, performance, safety rules and instructions of the machine, etc.

6) the operator should be trained on-the-job and on duty with a license;

7) the operator should check daily before each class of work; The user must establish the necessary rules and regulations and safe operation rules. 










Inspection, maintenance, maintenance and troubleshooting methods:

Fault phenomenon	Possible cause	Overhaul method
Do not work after turning on the  power supply,  no indication of work indicator	1.The power supply is not on or in bad contact 2.The circuit breaker in the control box is not closed 3.Fuse damage of controller	1. Connect the power supply, deal with the bad part 2. Close the circuit breaker 3. Find the cause, replace the mental fuse.
No automatic operation	1.The automatic working switch is not on or out of order 2.Sensor lines or not well connected. Sensor adjusting 3.distance is too close	1.Overhaul or replace automatic switch 2. Reconnect line 3. according to wiring diagram.  Readjusting the effective distance of the sensor